O2 Sensor
- 产品介绍
- Typical experiment
- Download
Introduction
♦ O2 Sensor can be used in the place where concentration of oxygen is required to be measured such as Photosynthesis of plant and decomposition of hydrogen peroxide in different catalyst.
Usage
♦ Before using the electrode, you have to add filling liquid. Screw off the cover of O2 Sensor electrode. Rinse the electrode cover and metal tube using deionized water. Swing to dry them respectively. Inject filling liquid into cover to fill three quarters of volume of it. Screw back the cover tightly.
♦ Connect sensor to datalogger and computer.
♦ Open SWR iLab to calibrate the sensor (refer to calibration).
♦ Place the electrode into environment to be measured.
♦ Click ‘Rapid experiment’, ‘Start’ and ‘Stop’ to carry out experiment.
♦ Preserve the electrode carefully to enhance its service life.
Notes
♦ Make sure there is no air bubble in the electrode.
♦ After using, discard the solution in the electrode cover.
♦ Preserve the electrode carefully to enhance its service life.
Typical experiment
Typical experiment
♦ Compare the decomposition of hydrogen peroxide catalase in different conditions
Others
♦ Check air quality
