Multirange Voltage Sensor

Introduction

♦  Multirange Voltage Sensor is used to measure the electric potential difference at both ends of the electrical equipment or circuits. Multirange Voltage Sensor divides the voltage it collects to measure the electrical potential difference in DC circuit and AC circuit. Multirange Voltage Sensor should be parallel connected to the circuit during using. The internal resistance of Multirange Voltage Sensor is extremely huge. Thus, connecting Multirange Voltage Sensor will not affect circuit in most cases. In any part of circuit, Multirange Voltage Sensor can be used with current sensor.

Usage

♦  During using, connect red wire to high voltage end and black wire to low voltage end.

♦  If there are multiple voltage sensors in the circuit, to increase the accuracy, make sure they share the same ground (black wire).

Notes

♦  Multirange Voltage Sensor should be parallel connected to the circuit during using. Multirange Voltage Sensor needs to be calibrated before using.

♦  When measuring, please do not make the measured voltage exceeds the range of the sensor.

♦  If possible, ground the negative pole (black alligator clip) to ensure high accuracy.

Typical experiment

♦  Measure electrical potential of power supply and internal resistance

Others

♦  Measure VA characteristic of small bulb, diode and conductor

♦  Ohm’s law

♦  Series and parallel connection of resistor

♦  Electromagnetic induction phenomenon

♦  LC oscillation

♦  Series-parallel connection, charging and discharging of capacitor

Instruction Manual

Link: Instruction Manual【TS2128_Multirange Voltage Sensor】_ENG

Video