Multirange Current Sensor
- 产品介绍
- Typical experiment
- Download
Introduction
♦ ZC0004 Multirange Current Sensor is used to measure the current in circuit, can be used in DC circuit and low voltage AC circuit.
Usage
♦ Connect the Multirange Current Sensor to computer by USB cable.
♦ Open the SWR iLab V8.0 software.
♦ Click ‘New’ to create new experimental template.
Notes
♦ The Multirange Current Sensor needs calibration before use, the method please refer to the ‘Calibration’.
♦ The Multirange Current Sensor should series connect to circuit.
♦ The current goes into the sensor from the red conducting wire, and goes out from the black conducting wire and it shows a positive value, or it will show a negative value.
♦ When measuring, please do not make the measured current exceeds the range of the sensor.
Typical experiment
Typical experiment
♦ Measure the electrodynamic potential and internal resistance of battery
♦ VA characteristics of small bulb, diode and conductor
♦ Ohm’s law
♦ Serial-parallel circuit of resistance
